How to breed Jinhuangxing and what to pay attention to

Reproduction method of the golden star

There are four ways to propagate the genus Jinhuangxing: cutting propagation, sowing propagation, division propagation, and leaf cutting propagation. Generally speaking, the most suitable method of propagation is cutting propagation, because it propagates faster and is easier to plant.

Seed propagation of the golden star

The seeds of the golden star can be propagated, and are usually planted in spring, but its seeds are difficult to obtain. The natural reproduction method of the golden star is seed propagation, but seed propagation is generally not used because it takes a long time.

The breeding time of the golden star

The cutting method can be used to propagate the succulent plant, which should be carried out in the autumn of each year. The survival rate is the highest at this time because the temperature and climate at this time are most suitable for its growth and the temperature is also the most suitable.

How to breed Jinhuangxing

Propagation of the genus Jinhuangxing by division

When propagating the genus Artemisia by division, it is necessary to wait until its mother plant grows more sub-plants. The method of division is not difficult. Just separate the sub-plants around the mother plant and then plant them in separate pots. Division is generally better done in spring.

Cutting propagation of Jinhuangxing

When propagating the genus Artemisia by cuttings, you need to use healthy branches without diseases and insect pests, and cut the branches of the genus Artemisia, the length of the branches should be about 10 cm, and then insert the branches directly into the sand. Generally, it will take about 10 to 15 days for the roots to take root.

Seed propagation of the golden star

Although the genus Aster can produce seeds, the commonly used method of propagation is still cuttings, which is usually carried out during the growth period. Either leaf cuttings or branch cuttings can be used, and both can survive.

Propagation of Jinhuangxing leaf cuttings

For leaf cuttings of the Aster scabra, you can usually cut off the leaves of the Aster scabra that are growing too tall or not looking very good, and place them in a ventilated place to dry. After the cut is dry, insert the leaves of the Aster scabra or lie flat on the sand bed, keeping it slightly moist. It will usually take about 20 days for roots to grow.

Things to note when breeding Jinhuangxing

1. The substrate used for cutting propagation of the genus Polygonum multiflorum must be well-drained and breathable, and a mixture of coarse sand and fine sand can be used.

2. The temperature should be kept at 20-23℃ for the easiest rooting of the genus Polygonum.

3. Do not water the plant in large quantities immediately after it takes root, otherwise it will easily cause root rot.

4. The survival rate of leaf cuttings is lower than that of branch cuttings. Therefore, for first-time flower lovers, it is better to use branch cuttings for propagation, which is simpler and easier to survive.