In the summer, you can use empty soda cans to cut with scissors and use them to grow flowers, which is great!

Cans as Cactus Pots

Author: L-QING

Source: 163 Blog

Steps:

1. Draw a line on the can at the height you like, and cut along this line when you cut it later. If you are planting something small like a cactus, you don't need too much soil and can draw it lower.

2. Use scissors to cut the can along the line you drew on it. Be sure to watch your hands when cutting to avoid getting hurt.

3. Use scissors to evenly cut the cans into long strips about 7 cm wide. Then, as shown in the figure below, use chopsticks to turn the aluminum sheets of the cans inside out to make beautiful petal shapes.

4. Open a drainage hole at the bottom of the can. You can use the whetstone for sharpening kitchen knives at home to do it.

5. With just a few simple steps, a simple small flower pot can be made.

6. The small flower pots made of cans are used to grow flowers such as cacti, which are so beautiful!

Cans for succulent flower pots

Author: Love Meat

Source: Sina Blog

Steps:

1. Find a can, cut off its bottom, then trim off all the burrs on the cut, and try to make the cut surface smooth.

2. Use copper wire or iron wire to make a circle that can just fit around the outside of the can.

3. Cut the can about 2 cm vertically. The number of cuts can be an even number, which will make the result more beautiful. Then put the previously made circle on it.

4. Fold the edge of the can downwards after each piece is removed and wrap it around the circle.

5. After it is completely wrapped, it will look like the picture below.

6. Find a toothpick, cut off about 3 cm of the tip, and roll it up with a can until all the raised edges of the can are rolled down.

7. Take the bottom of the can that you cut off earlier, and place it with the concave side facing down on the inner bottom of the can. In this way, a small flower pot is ready.

8. Add soil to the prepared can flowerpot, and then put the plants you want to plant in it.

Can lid cut cabbage

Steps:

1. Cut the cabbage horizontally into two parts, keeping the stem of the cabbage.

2. Fold the lid of the can in half, then put your finger into the pull ring and cut the stems of the cabbage. Each piece can be cut into several layers.

3. Cut off the excess part of the cabbage, and be careful not to cut off the cut part, otherwise all your efforts will be wasted.

4. Spread the cabbage in water and it will become beautiful cabbage flowers.

Cans for air pineapple flower pots

Steps:

1. Prepare two beer cans and a small plant, such as aloe vera.

2. Draw an oval on white paper and cut it out. Use it as a template to cut a hole on the side of the can.

3. The edges of the cans cut in this way are relatively sharp. In order to prevent your hands from being pricked, you can make a small trim along the edge of the can and fold the cut part inwards. This way you don’t have to worry about scratching your hands.

4. Wash the trimmed cans again, let them dry, apply a white base coat, and then paint your favorite patterns or colors.

5. After drawing, the can will look like the picture below.

6. Put the soil in it, and then plant the small aloe vera plant prepared earlier into the soil. This will make a small can flower pot. Then hang a rope on the top of the can and hang it anywhere.