What are the methods and precautions for growing tiger tail orchid? Key points of tiger tail orchid cultivation skills

Tiger Pilan cultivation methods and techniques

temperature

Tiger tail orchid likes a warm environment, we need to control the temperature between 20-30 degrees Celsius. In winter, the plant is kept indoors, and the temperature cannot be lower than 10 degrees Celsius.

In summer, we need to cool down the plant, because the tiger tail orchid always rots due to high temperature in summer. If this happens, we need to remove the rotten part of the plant and repot it. Then put the tiger tail orchid in a cool and ventilated place for maintenance, and it will grow very well.

Watering

Tiger tail orchid is relatively drought-resistant , so watering should not be too frequent. Generally, wait until the pot soil is completely dry before watering, and water thoroughly. The key is that there should be no water accumulation at the bottom of the pot, otherwise it will easily cause root rot.

Don't water the tiger tail orchid too often, otherwise it will easily cause root rot. We can wait until the pot soil is completely dry, then water the plant thoroughly. Then put the potted plant in a ventilated place for maintenance to accelerate the evaporation of water, which is conducive to the growth of the plant.

illumination

Tiger tail orchid likes light, but avoids direct sunlight. We should place the plant on a balcony or bay window with good lighting so that the tiger tail orchid can receive sufficient scattered light.

Although Tiger Tail Orchid likes light, we need to give the plant sufficient diffuse light and not expose it to the sun. Especially in the hot summer, the sun will make the leaves of Tiger Tail Orchid turn white and slowly wither and rot.

Precautions for breeding of tiger tail orchid

1. There are two methods of propagation of Sansevieria trifasciata: division and cutting. In comparison, the survival rate of division is relatively high.

2. It is usually time to change the flowerpot in spring. The method is to cut off the leaves that grow too densely with a sharp blade, and plant them in the flowerpot with the suckers and rhizomes.