When is the best time to prune cypress trees?

Pruning of cypress trees

The skeleton branches of the dragon cypress should be cultivated from the seedling stage, so regular pruning and maintenance are closely combined. This will ensure that the tree has an upright shape, a correct posture, no branching, and no loose feet, thus improving its ornamental value.

Cypress tree pruning time

The dragon cypress trees are pruned in spring and autumn respectively. The amount of pruning is less, but when pruning is necessary, it should be done in time and not delayed. Shaping and pruning are generally done twice a year.

Propagation of cypress tree by cutting

There are two times for cuttings of cypress trees each year, namely from early February to early March in spring, and from late October to November in autumn.

How to prune cypress trees

1. The pruning of arborvitae is mainly pinching. During the vigorous growth period in summer, it is necessary to pinch and top out in time, otherwise it will affect the appearance. Pinching should be done by hand, not with scissors, to avoid damaging the leaf buds on the branches. Pinching should be done at least 4-6 times a year. During the pinching process, it is necessary to do a good job of guiding the trunk, hanging and tying the main trunk to ensure the advantage of the main trunk.

2. During the maintenance of the arborvitae, you will find that the branches are reverting to their original roots. The thorny leaves should be cut off in time. In addition, on snowy days or after entering a dormant state, it is easy to be affected by the snow pressure, causing the ball shape to loosen, affecting the landscape effect. Therefore, you can use straw ropes to tie them for 1-2 months. If you see dense branches and old branches, you need to trim them in time.

Precautions for pruning cypress trees

During the growth period of the Dragon Cypress tree, it is necessary to pinch the top in time to make it lush and leafy, and trim the thorny leaves. When pruning, do not do it too hard to avoid leaving large cuts or holes. It is best to do it in several times. The general requirement is that the distribution of new shoots is visually reasonable and beautiful.